Commercial Gates & Access
The controlled point of the perimeter.
A commercial gate is a structural decision as much as a fencing one. Width, frame weight, hinge and post design, operator compatibility, and how vehicles actually arrive at the opening all decide whether the gate works for the life of the site or becomes a maintenance call. We fabricate and install commercial gates for equipment yards, facility entrances, utility compounds, and controlled-access sites, and we coordinate the frame and hardware with whatever access control is being specified.
Gate types we build
Swing gates, sliding gates, cantilever and overhead slide configurations, and double-drive entrances, in steel frame with the infill matching the fence spec. Security and utility compounds usually call for a frame built to the operator's requirements; public-facing entrances often call for a combination of steel frame, architectural infill, and masonry or stone work.
Frame, post, and hinge design
The gate leaf carries load every time it moves, and the post carries the leaf. Posts are sized and set for the span rather than matched to the fence line, and hinges are designed so the gate does not sag into the ground within a year. On wider openings we look at operator requirements first, because an operator cannot fix a frame that was built too light.
Operators and access control
We build gates to accept the operator being specified, provide mounting and wiring provisions, and coordinate with the operator supplier and the electrical scope so nothing is discovered at commissioning. Where the site needs card readers, keypads, loops, or intercom, the gate frame is built to receive them.
Working inside a project schedule
Gate work is usually on the critical path because it is the last thing that lets a site be secured. We coordinate fabrication lead time, site access, and concrete cure against the project schedule, and flag early when a gate opening in the field does not match the drawings.
Common questions about commercial gates & access.
Do you install gate operators?
We build gates to the operator spec and coordinate installation and access control with the operator supplier and electrical contractor. Send the operator being specified with the plans so the frame and provisions match.
How wide can a commercial gate be?
It depends on the type. Swing gates have practical width limits based on frame weight and operator capacity; sliding and cantilever gates handle much wider openings. The right configuration depends on traffic and available clearance along the fence line.
Can you match gate infill to the fence?
Yes. Gate frames are built with infill matching the fence specification, whether that is chain link, welded wire, ornamental pickets, or steel panel.
How long does a commercial gate take to fabricate?
Fabrication lead time depends on size, infill, and hardware. It is scheduled against the project timeline at bid stage so the gate does not become the reason a site cannot be secured.
Have a project that needs a fencing subcontractor?
Send us the plans, the spec and the timeline. We'll review the scope and respond — whether it's a bid invitation or a full perimeter package.