Pipe Fencing by 5-7 Fencing & Construction in Texas
Ranch & Agricultural

Pipe Fencing

Welded steel. Built for a lifetime.

Pipe fence is what you build where a fence has to survive contact. Corrals, working pens, entrances, highway frontage, and any place equipment or heavy cattle will hit the line. It is also the fence that most clearly shows whether the welder knows what they are doing: a pipe fence that was notched, fitted, and welded properly looks the same on day one as one that was not, and behaves completely differently three years later. We build pipe fence and pipe-and-wire combinations across our service area, and we fabricate on site where the job calls for it.

When pipe makes sense

Pipe costs more per foot than wire, so it earns its place where pressure and contact are real: corrals, pens, load-out areas, entrances, gates, and frontage along roads. Many of our ranch projects use a pipe-and-wire combination: pipe at corners, entrances, and lane divisions, wire for the long runs between. That gets the durability where it matters without paying pipe prices for a mile of pasture boundary.

Pipe size, wall thickness, and welding

Two-and-three-eighths and two-and-seven-eighths are the common ranch sizes, with heavier wall for pens and gates. Joints are notched and fitted rather than butted and burned, and welded full around so water cannot get into the joint and rust it from inside. We cap open ends and finish welded areas so the fence is not rusting from day one.

Setting posts and bracing

Pipe set in ground with no bracing is a lever. We set posts to proper depth, brace corners and gate posts, and use diagonal or horizontal bracing on long runs and heavy-contact panels. On rock, we set differently than in sand, and we will tell you before the job starts if ground conditions are going to change the approach.

Gates, entrances and finishing

Gates are built to swing true and latch under load, with hinges and frames sized to the opening. Entrance work often combines pipe, custom signage frames, and masonry or stone columns, and we build those together so the entrance is one piece of work rather than three trades fighting over it.

Completed Work

Pipe Fencing from our own jobs.

Every photo below is from work we built. Open any image to see it full size.

17 Photos
FAQs

Common questions about pipe fencing.

How much does pipe fence cost per foot in Texas?

Pipe fence costs considerably more per foot than wire fence because of material and welding labor. Price depends on pipe size, wall thickness, rail count, post spacing, and how much of the run is braced or gated. We quote after walking the job.

How many rails should a pipe fence have?

Three rails is common for corrals and pens where cattle pressure is heavy; two rails is often enough for a decorative entrance or a light boundary. The right answer depends on the stock and whether equipment will be working against it.

Can you build pipe-and-wire combination fence?

Yes, and it is one of the most practical builds for working ranches: pipe at corners, entrances and divisions, with wire run between. It puts the expensive material where the pressure is.

Do you weld on site?

Yes. On larger and remote jobs we weld on site, which keeps panels fitted to the actual ground and avoids hauling finished sections that do not line up.

Will pipe fence rust?

Bare steel pipe will surface rust over time, and many landowners prefer that look. We cap open ends and finish welds so the pipe is not rusting from the inside, and painted or coated finishes can be discussed depending on the application.

Ranch & Agricultural

Let's talk about your project.

Tell us what you're building, where it is, and what you need. We'll come look at it and give you a straight answer.